![]() ![]() So I am stumbling through with this command line setup.īut as long as I am connected via CAT5 I can get to no problem (Much improvement from the version I was running.) but not. I guess what my issue is I am not a command line guy and was used to using Xwindows or something like that to do all my set up in the past. It was also working before switching to the image. I thought this dongle from what I read and in the past that it should load automatically for Raspberry. Wlan0: ERROR while getting interface flags: No such device I did some reading and tried setting up my WIFI via the command line but it can’t see the TPLINK TL-WN725N. ![]() So I am not sure what is in the index.html file. I can’t view the file because as far as I can tell there is not text reader on the image. I have a TPLINK TL-WN725N that is working fine. ![]() OR is there a way when I log in to the Pi it self? In the past I used LXDE to do the set up but with this image I can’t get it to run. I am just wondering if I am just not looking at the right thing or I messed up the SD install. I can go to and see the open sprinkler program.įrom the instructions I guessing at there is a way to set up WIFI but I not seeing anything else on it. I followed the instructions and plugged my Pi into my network, got an IP but when I try to got to and see the ” see a welcome page with further instructions” I get it is unreachable. I guessing it is a more stripped down version than the one I originally loaded. I decided to use the pre-configured SD card image. I decided to update it when I had to change my network up when I got a new router. I had a early version of OSPi running for a over a year now. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |